RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: vertical grimmace
Showing results 1 to 7 of 7
Search took 0.04 seconds.
Forum: Kit Building
02-03-2015, 09:57 PM
Replies: 2,472
Views: 543,422
Posted By vertical grimmace

Why not something like this? I seem to recall...

Why not something like this? I seem to recall mine having a Dural gear, not wire.
...
Forum: Kit Building
01-29-2015, 01:13 PM
Replies: 2,472
Views: 543,422
Posted By vertical grimmace

Just for clarity, "Sweep" is when the wings, tip...

Just for clarity, "Sweep" is when the wings, tip has been moved back relative to the root, moving thickest part of the airfoil aft. This creates a longer nose moment, and gives more stability in...
Forum: Kit Building
01-29-2015, 11:15 AM
Replies: 2,472
Views: 543,422
Posted By vertical grimmace

Mark the fuselage 2.5" back from the leading edge...

Mark the fuselage 2.5" back from the leading edge of the bottom wing, on both sides. Flip the plane over and put your fingers at your sharpie marks. I always balance my planes at the fuselage....
Forum: Kit Building
01-29-2015, 08:32 AM
Replies: 2,472
Views: 543,422
Posted By vertical grimmace

It has been a while since I had a CG Ultimate, ...

It has been a while since I had a CG Ultimate, but can't you still check the balance inverted so you can use the bottom wing for support, and just use your fingers? It is not that big of a plane. ...
Forum: Kit Building
01-29-2015, 04:14 AM
Replies: 2,472
Views: 543,422
Posted By vertical grimmace

The specs I saw on the YS 120 compared to the VV...

The specs I saw on the YS 120 compared to the VV 20 cc shows the 20cc is 1 ounce heavier with ignition. This does not include ignition battery. Unless a BEC is used.
Forum: Kit Building
01-28-2015, 04:42 PM
Replies: 2,472
Views: 543,422
Posted By vertical grimmace

Get 2-56 threaded nyrod. Use the threaded...

Get 2-56 threaded nyrod. Use the threaded clevis end at the control surface, then make a Z bend at the servo. Support the nyrod sheath/tube, well to avoid flexing.
Forum: Kit Building
01-11-2015, 09:41 PM
Replies: 2,472
Views: 543,422
Posted By vertical grimmace

The Nobler was kitted by Top Flite.

The Nobler was kitted by Top Flite.
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.