RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Navy_Flyer
Showing results 1 to 7 of 7
Search took 0.04 seconds.
Forum: Kit Building
09-21-2021, 03:15 PM
Replies: 2,472
Views: 543,443
Posted By Navy_Flyer

It was not in a stall.

It was not in a stall.
Forum: Kit Building
09-17-2021, 11:08 AM
Replies: 2,472
Views: 543,443
Posted By Navy_Flyer

My radio is a 1992 Futaba 7UAFS (Super). I...

My radio is a 1992 Futaba 7UAFS (Super). I converted it from 72mHz to 2.4 with a module and new receiver. Used in other aircraft without any issues.
Forum: Kit Building
09-16-2021, 01:49 PM
Replies: 2,472
Views: 543,443
Posted By Navy_Flyer

Rekitted ! Doh!

So I maidened my ship. Saito 125. Great first flight! Not much trim adjustment needed. Greaser landing. Cleaned up and went home. Checked everything tight and secure.
Next trip to the field...
Forum: Kit Building
06-28-2021, 09:18 AM
Replies: 2,472
Views: 543,443
Posted By Navy_Flyer

Appreciate that. The batteries were less than 6...

Appreciate that. The batteries were less than 6 months old, and I had cycled them recently and got over 2100 mah out of them. Still well within performance expectations of them, under load. Power is...
Forum: Kit Building
06-27-2021, 04:43 PM
Replies: 2,472
Views: 543,443
Posted By Navy_Flyer

Cumulus Granite - radio failure killed my Ultimate

Today I took the Ultimate out for only my second flight of her. Everything checked in preflight. Engine was strong (Saito 150) and controls normal. Taxi around ok. Takeoff run straight and true -...
Forum: Kit Building
10-09-2020, 09:20 AM
Replies: 2,472
Views: 543,443
Posted By Navy_Flyer

to be clear I am referring to the lower wing....

to be clear I am referring to the lower wing. Front has two dowels and rear has one bolt in the center of the trailing edge.
Forum: Kit Building
10-07-2020, 07:45 AM
Replies: 2,472
Views: 543,443
Posted By Navy_Flyer

Wing hold down modification?

New to this forum. Just acquired a partially finished ARF (stabs attached). I am looking at the factory installed bottom wing hold down block, the hole does not align with the pre-drilled hole in the...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.